Enamel PF-115 "May"

Description

Characteristics

Colors

White, black, yellow, red, green, salad, blue, gray, brown, blue

Precautionary measures

Carry out painting work in a well-ventilated area. Use personal protective equipment for respiratory organs, eyes, skin.

Enamel consumption for a single-layer coating

1 kg per 5-10 m2

Coating resistance to static impact of water at a temperature of (20 ± 2) ° С, hour, not less

2

Coating adhesion, points, no more

2

Flexural elasticity of the film, mm, no more

2

Strength of the coating upon impact on the device of the U-1 type, cm, not less

30

Coating hardness according to the pendulum device of the TML type (pendulum A), relative units, not less

0,15

Hiding power of the dried coating, g / m2, no more

100-250

Flash point in a closed crucible, ºС (class 3, subclass 3.3)

23 or more, but less than 61

Grinding degree, micron, no more

50

Nominal viscosity according to a viscometer of the VZ-246 type with a nozzle diameter of 4 mm at a temperature of (20.0 ± 0.5) С, s

140-220

The gloss of the coating at an angle of illumination of 45 ° according to the device of the BF-5 type, units, not less

20

Drying of each layer of enamel at a temperature of (20 ± 2) С

24 hours

Mass fraction of non-volatile substances,%

50-80

Note

An increase in the relative viscosity of the enamel is allowed during storage, if the enamel, when diluted with a solvent to the viscosity specified in paragraph 4, meets the requirements and values of these technical requirements.

Structure

alkyd varnish, pigments, targeted additives, solvents, desiccant